1997 Ski-Doo Factory Shop Manual Volume Three, Page 75Get this manual

1997 Ski-Doo Factory Shop Manual Volume Three, Page 75

Sub-Section 03
Section 03 ENGINE (LEAK TEST AND ENGINE DIMENSION MEASUREMENT)

RECTIFYING SURFACES
Stick fine sand paper sheet on the surface plate then lightly oil the sand paperRub manifold mating surface on sand paper using 8-figure movementsSand until mating surface is perfectly straight
A01C3HA

ENGINE TYPE All

NEW PARTS MIN MAX0.03 0.012 mm (.0001 .0005 in)

WEAR LIMIT 0.015 mm (.0006 in)

Back to 1997 Ski-Doo Factory Shop Manual Volume Three