1997 Ski-Doo Factory Shop Manual Volume One, Page 242Get this manual
Section 06 REAR SUSPENSION Sub-Section 04 (DRIVE AXLE) A00F0AA
A00F0DA
1Plane surface A1.5 mm (116 in) MAXIMUM
zation is found to be defective, use new sprocket
The must notCAUTIONtwicesame sprocketsynchronibe pressed on the axleIf
The bearing on the splined side of axle must be pushed until it is seated on shaft shoulderThe end bearing housing bearing must be flush with end of drive axleEach bearing must have its shield facing the sprocket1
6,8, Drive Axle and Seal
When assembling drive axle, always position new seal on each end of drive axle (chaincase side only on Tundra II LT)Locate seal lip as illustrated1 2
A00F05A