1997 Ski-Doo Factory Shop Manual Volume One, Page 234Get this manual
Sub-Section 03
Section 06 REAR SUSPENSION (SC-10 SPORT AND TOURING SUSPENSION)
' when unscrewing screws assembled with threadlocker, proceed as follows :
Knock on screw head andor heat to break threadlocker bond Loosen one screw then retighten Remove the opposite screw Remove the first one
NOTETo prevent cross shaft from turning
Unscrew center idler wheel axle from tunnel then removeLift rear of vehicle until spacers, idler wheels, washers and springs can be removed
A03F13A
1Stroke limiter on rear side
8,9, Pivot Arm and Flat Washer
At installation pivot arm grease fitting must face rearwardSmall washer must be against nutLarge washers must be inside rails on both side