1997 Ski-Doo Factory Shop Manual Volume One, Page 196Get this manual
Section 05 ELECTRICAL Sub-Section 05 (BATTERY)
Remove corrosion from battery cable terminals and battery posts using firm wire brush
This chart will be useful to find the correct readingELECTROLYTE TEMPERATURE 38 32 27 21 16 10 -1 -7 -12 -18 -23 -29 -34 -40 100 90 80 70 60 50 40 30 20 10 -10 -20 -30 -40 add .008 .004 .004 .008 .012 .016 .020 .024 .028 .032 .036 .040 .044 .048 to the reading OPERATION TO PERFORM
INSPECTION
Visually inspect battery casing for cracks or other possible damageIf casting is damaged, replace battery and thoroughly clean battery tray and close area with water and baking sodaWARNINGShould the battery casing be damaged, wear suitable pair of non-absorbent gloves when removing the battery by handInspect battery posts for security of mountingInspect for cracked or damaged battery caps, replace defective capsWARNINGBattery caps do not have vent holesMake sure that vent tube is not obstructed;
correct reading
subtract