1997 Ski-Doo Factory Shop Manual Volume One, Page 160Get this manual
Section 04 TRANSMISSION Sub-Section 06 (BRAKE)
INSPECTION
7, Brake Pad Thickness
Brake pads must be replaced when fixed pad projects only mm (132 in) from caliperCAUTIONBrake pads must always be replaced in pairs
7, Fixed Brake Pad
Tundra II LT Torque screw no3 to Nm (35 lbfin)Bend locking tab no4 over flat of screw head-
1,6,11,12, Locking Tab, Inner, Outer Caliper and Nut
Tundra II LT Assemble both caliper halvesInsert bolts no9, locking tab no20, then nutsTorque nuts to 24 Nm (18 lbfft)Caliper half side slots must align to allow proper sliding in brake supportBend locking tab over flat of each nutInstall rubber slider no12 lubricated with shortening (cooking fat) into side slots of caliperIt must be installed so that the raised edge is upward and on the same side of nuts as shown1
A15D03A
TYPICAL 1Fixed pad 2Inner caliper A1 mm (132 in) minimum
Brake Disc
Check for scoring, cracking or heat discoloration, replace as requiredRefer to DRIVEN PULLEY 0404 for replacement procedures on Tundra II LTCAUTIONBrake disc should never be machined