1997 Ski-Doo Factory Shop Manual Volume One, Page 143Get this manual
Section 04 TRANSMISSION Sub-Section 04 (DRIVEN PULLEY)
12, Fixed Half Shaft
Thoroughly clean the fixed half shaftRemove rust with no320 grit sand paperApply light film of anti-seize lubricant (P413 7010 00) on the shaftAlways wipe off surplusNOTEActivate the sliding half several times to distribute lubricant over full length of shaftBe careful that lubricant does not get on inner halves of pulley
' slackened, chaincase can be reinstalled to its initial position by securing driven pulley support
NOTEIf chaincase screws have been
before tightening chaincase retaining screwsMake sure to install alignment shims as noted at removalCAUTIONBleed oil injection pump on models that have had their injection oil supply line removedRefer to INJECTION OIL SYSTEM 03-06
13,14, Brake Disc and Screw
Install brake disc on fixed half and torque screws to 13 Nm (115 lbfin)Assemble driven pulley components by reversing the disassembly procedure
ADJUSTMENT
10,11, Shim