1997 Ski-Doo Factory Shop Manual Volume One, Page 137Get this manual
Section 04 TRANSMISSION Sub-Section 03 (DRIVE PULLEY)
6,25,29, Sliding Half, Slider Shoe and Governor Cup
To install governor cup, use following tool :
529 0055 00
A16D0EA
A16B01A
Insert spring and slider shoes into governor cup so that groove in each slider shoe is vertical to properly slide in guidesCAUTIONMake sure O-rings are installed on slider shoes and their grooves are positioned verticallyInstall fork (P529 0055 00) into slider shoe grooves to maintain them for governor cup installationProceed on set of slider shoes
Carefully slide governor cup into sliding halfAlign mark of governor cup with mark of fixed halfRemove forks and push governor cup so that its splines engage with fixed half shaft splinesCAUTIONMake sure splines of both parts are fully engaged
INSTALLATION