1996 Ski-Doo Shop Manual, Volume 3, Page 306Get this manual
Section 08 STEERINGFRONT SUSPENSION b-S ectio 01 (S TE ERIN M)
Skandic WT Only Install spe cial ash ers (locking disks) ith te eth facing each others
9,13,15, ll oint ut and ut
Tighte ball joint, nuts and jam nuts to specified torqu (se explod ed vie )
1Larg te eth
All Models Except Skandic WT
17, Ste erin m
Th ste ering arm angle should be qual on both side en skis are parallel ith ve hicle Ste ering arm ust run parallel to ski
9, F-S eries Ve hicles ith astle ut
After prop er torqu has applied to the ball joint nut, insert cotter pin through th hole in the tie rod nd bending the nds around th nut as sho in th follo ing illustrationA 02D08 A