1996 Ski-Doo Shop Manual, Volume 3, Page 244Get this manual
Section 06 ELECTRICAL b-S ectio 05 (ELEC TRIC TA RTER)
Prior to ass bling, co at slidin surfac and moving parts on arm ature shaft splin es, overrunning clutch, sole noid itch plunger, drive lever and bushings ith .EVersilube 321 (P413 7040 00) lubricantProce ed as follo for asse blingSecure drive housing in viseC TIrtig si ce usin ig ht d
A 19E05 A
1Cut close to conn ector
12,13, Sto ollar and Circlip
Re move burrs ith file on the re aining eld ed portionC TIOca refu ot to pla stic ortio kePlace spare brush plate edge against yoke conne ctor dg (w eld ed portion)Crimp plate over yoke conne ctor ith pair of pliers
Install overrunning clutch onto arm ature shaftInsert in er collar onto shaftInstall ne circlipC TIin st ll circli serv icin gInsert ut er collar eing careful to atch protrusions ith notch es of collarsUsing pair of pliers on each side of stop collars, squ ez eve nly until collars sit over circlip