1996 Ski-Doo Shop Manual, Volume 3, Page 187Get this manual
Section 05 TRANSMISSION b-S ectio 02 (DRIV PU LLEY)
This adjustable drive pulle allo setting aximu engin RP in the vehicle to aintain maxim um po erCalibration scre should adjust ed so that actual axim um ngin RP in ehicle atch ith the axim ors po RP give in TE NIC ATA 10NUse pre cision digital tacho ter for engin RP adjustm ntNTh adju st nt as an ff ct on high RP onlyTo adjust, odify ram nd position by turning calibration scre s
Each nu mb er odifie maxim um engin RP by about 200 RP Lo er num bers de crease engin RP in ste ps of 200 RP and higher num bers increase it in steps of 200 RP Exam plealibra tio cr is sitio an is chang ed to position 6So aximu engin RP is incre ased of 400 RP To dju stJust loose locking nut enough to pull calibration scre artia lly out and adjust to esire positionDo not com ple tely re move the locking nutTorque locking nuts to 10 Nm (89 lbfin)C TIcalib ra tio scre its in sid ash ill fall ffC TIOdju st ll calib ra tio scre and ake sure th re all set th sa er