1996 Ski-Doo Shop Manual, Volume 2, Page 176Get this manual
Section 05 TRANSMISSION b-S ection 07 (G RB X)
S prockets and ars
Ch eck te th
Reinstall drive shaft2
25, arb usin g
Reinstall earbox housingNdjust nt scre can only installe en housing is re movedDo not re use re oved oil se alsRe place th by ne one sInstall drive axle ith track the earing and circlip in chaincase bore Install spacer o38 ith its large outer diam ter against sprock et, sprocke 34, coupling shaft 33, cap 40 and scre o31Place 25 cm (10-inch) rule against sprock etsM axim um allo able offset is (.040 in)aIf upp er sprock too far in, possible cause are1C ountershaft earing on driven pulley side may be too far inTo che ck, pull out be aring using count ershaft aring xtractor (P529 0301 00) th re ch ck sprocke alignm ntUse earing installer (P529 0302 00) to re position aringB aring housing (triangle) ust against fram ithout preload2Add shim(s) et en chaincase and fram and reposition bearing on drive pulle side accordinglybIf upp er sprocket is too far out, che ckIf there are too any shims et en chaincase and fram Re move shim accordingly and reposition be aring on driven pulley side