1996 Ski-Doo Shop Manual, Volume 2, Page 155Get this manual
Section 05 TRANSMISSION b-S ectio 02 (DRIV PU LLEY)
Raise and block th rear of th vehicle and support it ith echanical standW INnsu re th at th tra ck is fre of article hich co uld th ro ut hile tra ck is ro atin gK ds, ols, fe et and clot hin cle ar of trackE nsu re is sta din ar th hicle Accelerate the ve hicle at interm diat spe and apply the brake, rep eat tim sRe torqu to 90 to 100 Nm (66 to 74 lbfft)Wft 10 rs ra ti the tr issi sy st the icle st ct the scre is ro erly to rq ;
A 16D0FA
DRIV LLE T
Th drive pulley is factory calibrated to transmit axim ngin po er at pre fin RP Factors such as ambient perature, altitude or surface condition ay vary this critical gin RP thus affe cting sno mobile efficiencyThis adjustable drive pulle allo setting aximu engin RP in the vehicle to aintain maxim um po erCalibration scre should adjust ed so that actual axim um ngin RP in ehicle atch ith the axim ors po RP give in TE NIC ATA 10NUse precision digital tachom ter for engine RP adjust ntNTh adjust nt as an ff ct on high RP onlyTo adjust, odify ram nd position by turning calibration scre s