1996 Ski-Doo Shop Manual, Volume 1, Page 318Get this manual
Se ion BODYFRAM Sub-Section 01 (BODY)
I ST ALLAT ON AN ADJ ST EN HEADLAMP BEAM AIMING
Beam aiming is correct when center of high beam is 25 mm (1 in) below the headlamp horizontal center line, scribed on test surface, 381 cm (12 ft in) awayMeasure headlamp center distance from groundScribe line at this height on test surface (wall or screen)Light beam center should be 25 mm (1 in) below scribed lineHeadlampcenter line
BULB REPLACEMENT
If headlamp bulb is burnt, tilt cab and unplug the connector from the headlampRemove the rubber boot and unfasten the bulb retainer clips or locking ring(TYPICAL)
381 cm (12 ft in)
, AO02 004010 25 mm (1 in) below headlamp center
A025 007019
Locking ring