1996 Ski-Doo Shop Manual, Volume 1, Page 315Get this manual
Se ion ST EERI G FRON SU SPEN SI ON Sub-Section 02 (SUSPENSION AND SKI SYSTEM)
DISASSEMBLY
Lift front of vehicle and support it off the groundReduce spring preload by turning adjusting ring accordingly with special key in vehicle tool box
1, Swing Arm
Lift front of vehicle and support it off the groundUnbolt skiRemove cap, circlip then slacken steering arm bolt and pull up steering armNote shim positionsSki leg may fall off from swing armUnbolt lower end of shock from swing armUnbolt half arms and tie rodsUnbolt rear of swing arm from framePull swing arm off the vehicleStabilizer bar will disengage ball joint at swing arm inside rails
AO06 006010
Remove lower bolt then upper bolt of shockFor shock spring disassembly, use shock spring remover (P5290271 00) in viseMount shock in it and turn shock so that spring coils matched spring compressorClose and lock barAdjust handle horizontal by changing position of clevis pinPush down on handle until il locksRemove spring stopper and cap then release handleAt installation, cap opening must be 180 from spring stopper openingAO06 006011