1996 Ski-Doo Shop Manual, Volume 1, Page 304Get this manual
Se ion ST EERI GFRON SU SPEN SI ON Sub-Section 01 (STEERING SYSTEM)
13,15, Tie Rod Jam Nut (LH and RH)
Loosen the jam nuts locking the tie rod in placeTurn tie rod manually until alignment is correctTorque jam nuts as specified in the applicable illustrationIMPORTANT: Close front of skis manually to take all slack from steering mechanismNOTErubber band can be hooked in front of skis to keep them closedNOTETo make sure skis are in straight-ahead position, place straight edge against pre-adjusted track and measure distance between front and rear of skis and straight edgeDistances should be equalAfter ski toe-out adjustment, distance at front of ski must be 3.3 mm (18 in) more than at rear on both sides for total toe-out of 6.6 mm (14 in)
AOO1 006004.2
Tundra II LT Adjustments should be performed following this sequence Pivot arm centering horizontal handlebar Set toe-outPIVOT ARM CENTERING HORIZONTAL HANDLEBAR Turn handlebar until pivot arm is well centered in slot of its bracketCheck if handlebar is horizontalTo adjust, loosen lock nuts of short tie rod and turn it accordinglyPivot arm