1996 Ski-Doo Shop Manual, Volume 1, Page 301Get this manual
Se ion ST EERI GFRON SU SPEN SI ON sub-se ion 01 (STEERING SYSTEM)
INSPECTION
Check skis and runner shoes for wear, replace as necessary(See section 08-02)
31, Heating Grip Element
On vehicle equipped with heating grips, grips might be unremovable as explained earlier, in this case, carefully proceed as follows to prevent damaging heating elementsLocate the grip heater wires inside handlebar; look through end of gripStart cutting grip exactly opposite heater wires and immediately peel open to locate gap in heating element, as shown
17,36, Steering Arm and Ski Leg
Make sure steering arm and ski leg splines interlock (if applicable)WARNINGAll parts having worn splines haveto be changed by new onesCheck general condition of steering systemCheck general condition of steering system components for wear and replace if necessary
DISASSEMBLY AND ASSEMBLY 8, Grip
Grips can be removed and installed without any damage by injecting compressed air into the handlebar or by heating them with heat gun1, Steering Column Remove steering pad then handlebar ass'yDetach short tie rod from steering column working under engineOn S-Series remove air intake silencer and carburetor(s) to gain access