1996 Ski-Doo Shop Manual, Volume 1, Page 294Get this manual
Se ion REAR SU SPEN SI ON Sub-Section 06 (TRACK)
S-Series 40 to 45 mm (1-916 to 1-34 in) when exerting downward pull of 7.3 kg (16 lb)(TYPICAL)
Alignment (bogie wheel)
#an With rear of vehicle supported off the ground, start engine and allow the track to rotate slowlyCheck if track is well centered and turns evenly on rear sprocketsDistance between edge of track and link plate must be equal on both sidesNOTESometimes, after reinstalling, sprocket teeth seem to skip out of track notchesApply liquid soap on sprocket teeth to correct
P40 to 45 mm(1-91 to 1-34 in) with 7.3 kg (16 lb) A025 005012
WARNINGBefore checking track alignment, ensure that the track is free of all particles which could be thrown out while track is rotatingKeep hands, feet, tools and clothing clear of track:
All Models CAUTIONToo much tension will result in power loss and excessive stress on suspension componentsIf too loose, the track will have tendency to thumpTo adjust, loosen the rear idler wheel retaining screws (one side only on Tundra II LT and S-Series) and the adjuster bolt lock nutthen loosen or tighten the adjuster bolts located on the inner side of the rear idler wheels