1996 Ski-Doo Shop Manual, Volume 1, Page 292Get this manual
Se ion REAR SU SPEN SI ON Sub-Section 06 (TRACK)
TRACK TYPE APPLICATION
Refer to TECHNICAL DATA sectionl 0, Tundra II LT Remove the following items chaincase cover, sprockets, chain muff Ier upper center idler ass'y suspension end bearing housing drive axle seal drive axle (outwards from end bearing housing) track S-Series Remove the following items speedometer cable muff Ier chaincase cover suspension drive axle seal end bearing housing sprockets and chain drive axle (toward end bearing housing) track
GENERAL
This section gives guidelines for track removalSome components require more detailed disassembly proceduresIn these particular cases, refer to the pertaining section in this manual
INSPECTION
Visually inspect track for cuts and abnormal wear broken rods broken or missing track cleats If track is damaged or rods are broken, replace trackFor damaged or missing cleats, replace by new ones, using cleat remover (P 5290082 00) for Elan and Tundra II LT (PN 5290287 00) for all other modelsUse large-cleat installer (P 5290288 00) or smallcleat installer (P 5290085 00)Elan