1996 Ski-Doo Shop Manual, Volume 1, Page 268Get this manual
Se ion REAR SU SPEN SI ON Sub-Section 01 (BOGIE WHEELS)
REMOVAL
Raise and block rear of vehicle off the groundRelease track tension by unlocking the link plate springs
DISASSEMBLY AND ASSEMBLY
4 ,5Side and Center Wheel Supports
Heat spring anchor on wheel support before attempting to open or close anchor
using an appropriate tool
3, Cross Shaft
Link plate springs
Clean then lubricate cross shaft with low temperature grease (P 4137061 00) before installation4,5,7, Wheel Support and Bearing Always pull or push bearing by inner raceWhen installing bearing on wheel support, position bearing shield towards inner flange, then press down until bearing is sitting flush with support endThen notch (3 notches) wheel support with cold chisel to secure the bearing in place
AOO1 005016
Cold chisel
1,2,3, Screw, Lock Washer and Cross Shaft
Starting at center bogie wheel set, remove screws and lock washers securing cross shaft to frame,