1996 Ski-Doo Shop Manual, Volume 1, Page 256Get this manual
Se ion ELECT RI CAL Sub-Section 06 (TESTING PROCEDURE)
6) Crank engine and observe indicator7) Push reset button and repeat step twice
Results :
a) Indicator lamp lightsIgnition module output is up to specificationsThe problem is faulty ignition coilb) Indicator lamp does not light: Proceed to following testIf magneto output tests good, the problem is faulty ignition module
AOOO OOd 055
MAGNETO OUTPUT (Ignition Generator Coil)
1Disconnect the 2-wire connector between ignition module and magneto harnessAt installation, secure with new locking ties2) Connect tester wires then set switch and dial as follows :
Tester wires Component wires BLACKRED wire of magneto harness BLACK wire of magneto harness Tester switch position Tester dial position