1996 Ski-Doo Shop Manual, Volume 1, Page 250Get this manual
Se ion ELECT RI CAL Sub-Section 06 (TESTING PROCEDURE)
Engine StopTether Cut-Out Switches Verification
Engine Stop Switch Unplug stop switch connector from main harness then using an ohmmeter, connect test probes to BLACK YELLOW and BLACK wiresMeasure resistance, it must be an open circuit in its operating position and close to ohm when depressedTether Cut-Out Switch Unplug tether cut-out switch connector from main harness then using an ohmmeter, connect test probes to BLACKYELLOW and BLACK wiresMeasure resistance, it must be an open circuit when cap is over switch and close to ohm when removedA17EOTA
Magneto System Verification
System verification can be performed using the Bombardier ignition tester (P 4190033 00), digital ohmmeter or by substituting parts
DUCATI CDI SYSTEM 1Combined ignition module lignition coil mounted on air silencer below carburetor(s) 2Two-wire connector (GREENI WHITE wires)
Ignition System Testing Sequence