1996 Ski-Doo Shop Manual, Volume 1, Page 194Get this manual
Section 05 TRANSMISSION Sub-Section 05 (BRAKE)
3,4,7, Screw, Locking Tab and Fixed Brake Pad
Tundra II LT Torque screw to Nom (35 Ibf"in)Bend locking tab over flat of screw head
17, Brake Disc
S-Series The brake disc must be floating on countershaft for efficient operation of brakeApply antiseize lubricant (PN 4137010 00) on shaft and check that disc slides freelyThe disc hub exceeds the disc more from one side than from the otherInstall disc with the Iorwer exceeding portion toward driven pulleyPush O-rings inside disc hub
2,7, Nut and Fixed Brake Pad
S-Series Torque nut to Nom (71 Ibf"in)1,6,11,12, Locking Tab, Inner, Outer Caliper and Nut Tundra LT Assemble both caliper halvesInsert bolts, locking tab, then nutsTorque nuts to 24 Nom (18 Ibfft)Caliper half side slots must align to allow proper sliding in brake supportBend locking tab over flat of each nutInstall rubber slider no12 lubricated with shortening (cooking fat) into side slots of caliperIt must be installed so that the raised edge is upward and on the same side of nuts as shownRaised edge upward and on same side of nuts