1996 Ski-Doo Shop Manual, Volume 1, Page 179Get this manual
Section 05 TRANSMISSION sub-section 03 (DRIVEN PULLEY)
ASSEMBLY
4, Cam Slider Shoe
When replacing slider shoes, always install new set (3 shoes) to maintain equal pressure on the camAssemble driven pulley components by reversing the disassembly procedure
ADJUSTMENT
Refer to PULLEY DISTANCE AND ALIGNMENT 05-04 to adjust pulley distanceAdjust drive belt height between pulley halves to obtain specified belt deflection
5, Spring
Spring Torsional Pre-Load To check spring pre-load adjustment, use spring scale hook (P 5290065 00) and spring scaleRemove drive beltInstall the hook on the sliding halfPreventing fixed half from turning, pull sliding half with the spring scale perpendicular with pulley axleTake measurement when opening driven pulley and another one when driven pulley begins to close after rotation of 10 mm (38 in)Spring pre-load is the average measurement between these 21st measurement 2"d measurement(when closing)Spring (when opening) pre-load 3.4 kg (7.9 lb) 3.6 kg (8 lb) Example3.8 kg (8.4 lb) (when opening)(when closing)Actual spring pre-load 2