1996 Ski-Doo Shop Manual, Volume 1, Page 174Get this manual
Section 05 TRANSMISSION Sub-Section 03 (DRIVEN PULLEY)
INSPECTION
6,9, Sliding Half Bushing and Bushing
Check bushings for wearSee F-Series driven pulley belowTo disassemble worn bushing (small), use press and suitable pusher(TYPICAL) Install bushing from this side of sliding half Bushing
A026 003021
After bushing installation, try fixed half shaft inside bushingIf it is too tight, use burnishing bar (PN 529 0264 00) then rettyIf it is still too tight, use burnishing bar with oil on it
, A026 003020
Remove screws and washers and pry large bushing out
3, Slider Shoe
Check cam slider shoes for wearReplace when inside edge of cam slider shoe slope is worn to mm (.039 in) or less