1996 Ski-Doo Shop Manual, Volume 1, Page 155Get this manual
Se ion RAN SM SSI ON Sub-Section 02 (DRIVE PULLEY)
CLEANING
2,3, Sliding Half and Fixed Half
Clean pulley faces and shaft with fine steel wool and clean dry clothClean sliding half bushing with clean dry cloth
Antiseize lubricant
AO02 003003
INSPECTION
Drive pulley should be inspected annually
2,3, Sliding Half and Fixed Half
Check sliding half for excessive lateral play and fixed half shaft for scratchesReplace as required
To tighten fixed half, use drive pulley puller (PN 529 0231 00) as shown in the removal procedure
ASSEMBLY
Make sure to install blocks at their original position and with their curved end toward governor cupThere must be calibration disks per block under the nylon threaded plug