1996 Ski-Doo Shop Manual, Volume 1, Page 122Get this manual
Se ion EN GI Sub-Section 05 (OIL INJECTION SYSTEM)
OIL PUMP IDENTIFICATION
7, Pump Lever
Different engines need different pumpsOil pumps are identified on their levers
ASSEMBLY
2, Oil Pump Gear
At gear assembly, apply light coat of low temperature grease (P 4137061 00) on gear teeth,
CAUTIONAlways mount proper pump on engineENGINE TYPE
4, Needle Roller
The needle roller must be engaged as deep as possible in the pump mounting flangeI
OIL PUMP IDENTIFICATION
5 ,6Spring Clip and Clamp
Always check for spring clips and clamps tightness
Torque to Nom (44 Ibfin)All Models Make sure cable barrel is well seated in oil pump leverSecure barrel with plastic washer and circlipVerify cable and oil pump lever operationo