1996 Ski-Doo Shop Manual, Volume 1, Page 89Get this manual
Se ion EN GI Sub-Section 01 (247 AND 277 ENGINE TYPES)
4,5,6, Generating Coil, Lighting Coil and Brake Lighting Coil
Whenever coil is replaced, the air gap (distance between magnet and coil end) must be adjustedTo check air gap, insert feeler gauge of 0.25-0.38 mm (.010 in.015 in) between magnet and coil endsIf necessaty to adjust, slacken reta;ning screws and relocate coil
8,13,16, Magneto Ring Screw, Air Deflector Screw and Junction Box Screw
At assembly of air deflector, magneto and junction box, apply Loctite 242 (P 4137030 00) on screw threads
12, Magneto Housing Nut
At assembly, thoroughly clean threads and apply Loctite 242 (P 4137030 00), then torque retaining nut to 85 Nom (63 Ibfft)
14,15, Protection Cap and Mass Cable
At reassembly, coat all electric connections with silicone dielectric grease (P413 7017 00) to prevent corrosion or moisture from penetratingCAUTIONDo not use silicone SEALANT, this product will corrode contacts