1989 Ski-Doo Repair Manual, Page 562Get this manual
Section 07 BODY IFRAME Sub-section 01 (BODY)
As preliminary set-up, adjust render to obtain distance of about 116 mm f4.57 in) between hinge screw and boltom of fender groove
Hinge screw
Temporarily iighten
._ 116111IYl _
1.4.57 ini
Tighten fender front screws and bottom ones on center panInstall hood making sure to place snow deflector under cab hingesHood hinges can be adjusted at the hood bracketTwo slots allow hood movement forwardrearward and up downBesides, hood hinges are slotted to allow left:' right movement
Adjust front portion of hood with fenders to obtain proper fit in fender groove and front of hood flush with front of fenders and center panAdjustment can be done either by hinge or fender movementAdjust rear portion of fender so that hood properly fit with console and fender grooves by slacking screw at rear of fender on top of inside bumperRecheck proper fit of components then tighten all hinges and fenders fasteners