1989 Ski-Doo Repair Manual, Page 561Get this manual
Section 07 BODYFRAME Sub-section 01 (BODY)
On right hand side, remove fasteners from brace connecting to ::;ki leg hOUSingNOTE: Pay attention to the possible presence of shims at the end of the bumper braceIf any, keep for installation
Center pan Secure to inside bumper and frameShould proper fil be difficult, shim(s) #36 can be added or removed to brace of inside bumper cOMecting to ski leg housingFender Install fenders to vehicleFirst install the center screw at the rear of the fenderInstall other screws beside, finger tighten only
NOTE: Center pan needs not to be disassembled prior to removing inside bumperIn this case, remove nuts in front of center pan first
ASSEMBLY
Assembly is essentially the reverse of disassembly procedures except that inside bumper, fenders and hood have to be adjusted to obtain prOper fitInside bumper Install fasteners close to upper column bracket and tighten, proceed each side of vehicle