1989 Ski-Doo Repair Manual, Page 540Get this manual
S.ction 08 STEERINGSKIS Sub-section 02 (SKI SYSTEM)
15.16Cotter pinaxle
Apply low temperature grease (PIN 413 7001 001 on axle prior to installingInstall new coner pin
8,9,11, Shaft, nutshock absorber
Torque spring nut to 29 N.m (21 Ibf.ftlWhen inRening shock absorber and shaft into ski leg, position shaft so 1hat the keyway on its top is oriented toward front of vehicle to properly ma1ch wi1h steering armke-,'Wa'r' ori e"ted
towar;:! front ot tthi(:k! Smaller pitr1 3t tile bott{im
1.2.3, Lplate, housingring
Torqu-:1 TO 29 NTI
(21 illl.11I
in10 housing making sure to insert plate tab into housing notch
19,22,23,26, Nut, screw, stop padski leg
Install stop pad with its higher step aimed forward and ski leg wi1h its angle side aimed rearward as shown