1989 Ski-Doo Repair Manual, Page 498Get this manual
Section 05 SUSPENSION Sub-section 09 (DRIVE AXLE)
ASSEMBLY
1,2, Drive axlesprocket
To assemble press fit sprockets, use press and suitable pipe as illustratedSprockets must be assembled according to the following dimensions
Ensure to align ind9xing marks on each sprocket before assembling the second sprocketThe maximum desynchronization tolerance for the sprockets is 1.5 mm(1!16 in)To check this toleranceplace axle assembly on plane surface and Measure the gap between sprocket teeth and surface
"'Ill 001 0117
tTYPICAL)
'Y twice on the 8xleIf synchroniz8tion is found to
be defective, use new sprock.et
CAUTION: The same sprocket must not be pressed
12.13Cap screwelastic stop nut
On Elan, torque nuts of 8)(le flanges to N.m (38 Ibf.lnlWhen reassemblinginstall new nut or apply loctite (or equivalent) on old threadsTighten in the follO'Ning sequence