1989 Ski-Doo Repair Manual, Page 477Get this manual
Section 06 SUSPENSION Sub-section 07 (HINGED SUSPENSION)
NOTE: The holes in the frame provide the possibility of relocating the Iront suspension arm to recover track tension adjustmentIt means that if the slide suspension adjustment screws are fully tightened and the arm is in the center holes in frame, it is possible to move the arm in the rear holes to ohtain track tension adjustment
Insert temporary cross shaft from outer side of vehicle to help aligning rear arm in center of vehicle
suspension
A011 DOS 0)1
NOTE; Be careful not to drive the vehicle long cross shaft (on the other suspension) out of the rear arm while inserting the tempOrary shaftAlign rear arm with cross shaft retaining hole, between both suspensionsthen at the same time, push vehicle long cross shaft through the remaining rear armThis way the temporary cross shaft will be driven outInstall cross shaft screws and torque to 48 N-m (35
Ibf-ft)A011 GOG 012 A017 005 030
"W CAUTION: Ensure that front suspension arms are at the same position each side of the arm