1989 Ski-Doo Repair Manual, Page 427Get this manual
Section 05 SUSPENSION Sub-section 02 (SLIDE SUSPENSION)
13,27Screwsliding support
Slide rear arm over slider pads, as shownRe-install sliding SI.Jpporl and screwTorque sere to 48 N-m 135 Ibfm CAUTION; Make $ure slider pads 28 are well inT stalledCheek sliding action when sliding $UPports are installed- Reposition vehicle on groundRemove chaincase and oil injection reservoir vent hole plugs
25, Screw
Torque four suspension retaining screws to 48 N-m (35 Ibf-f1)Upper idler
ACIDI liDS 010
w loosct
15,16,17, Clevis pin, shock absorbercotter pin
Apply downward pressure on the frameSecure the extended shock with clevis pin and new coUer pin(TYPICAL)
NOTE: Holes in the frame provide the possibility of relocating the suspension arms for additional track tension adjustmentIf the slide suspension adjustment screws are at maximum adjustment and the suspension arms are in the front holes of the frameit is possible to move the suspension arms to the rear hoies and obtain add i1iona track tension adjustment