1989 Ski-Doo Repair Manual, Page 413Get this manual
Section 05
SUSPENSION
(BOGIE WHEELS)
Sub-section 01
REMOVAL
Raise and block rear of vehicle off the groundRelease track tension by unlocking the link plate springs using an appropriate tool
NOTE: Since spring diameter may vary depending on actual installation location, it is important to identify the installation of each bogie wheel setObserve this position when reinstalling setsRepeat operation for remaining bogie wheel sets
DISASSEMBLYASSEMBLY
I .ink plilte springs
1, Wheel support
Heat spring anchor on wheel support before attempting to open or close anchor
5, Cross shaft
Clean then lubricate cross shaft with low temperature grease (PIN 413 7061 00) before installation
1,9, Wheel supportbearing