1989 Ski-Doo Repair Manual, Page 345Get this manual
Section 03 TRANSMISSION Sub-section 08 (GEARBOX)
28,67, Nutplanet carrier
Apply Loctite 242 in planet carrier shaft boresWith planet carrier installed on shaft, press shaft into planet carrier boreApply Loctite 242 on shaft threadsInstall and torque nut to 35 N-m (26 Ibf-ft)
1, Ball (handle)
Put Loctite 242 on handle threads
42, Tensioner ass'y
Ensure that roller turns freely
27, Planet carrier bearing
With suitable pusher, press bearing into planet carrier bore and lock in place with snap ring
59, Seal (countershaft)
Install seal in transmission case so that the seal rib is seated in the bore groove
35, Ring gear needle bearing
The bearing is press fitted into the ring gear and must be pushed down only from its stamped end CAUTION: Never pound the bearing into its housT ing with hammer or other impact tool, even in conjunction with the proper assembly mandrelPress
34.11 mm (1.343 inl