1989 Ski-Doo Repair Manual, Page 340Get this manual
Section 03 TRANSMISSION Sub-section 08 (GEARBOX)
45, Drive shaftcomponents
To reinstall the drive shaft components on the drive shaft, proceed as follows:- Install the driven pulley shaft side bearing #32 on the shaft using cylindrical steel tubeMaterial: cylindrical steel tube 32 mm 11-1 4 in) a.D26.8 mm (1.005 in) I.D-];::::, 11-14 in) [
To obtain the proper drive shaft clearance it may be necessary to add or remove shim{s) between the key side bearing and the shaft bearing shoulder
28,38, Sprocket alignment
Verify sprocket alignment using the alignment tool (P 420 476 010) Proceed as follows:Set alignment tool on shift sprocket 19 th #28 and turn it into the corresponding layshaft and tensioner sprockets as illustrated_
j267 mrn 110-1112
A017 003 007
- Install the circlip over the bearing-Install the remaining components- Install the other shaft end bearing with shim{s) as required using the above mentioned tool- Available shims:
25.5340.2 (PIN 420 9444 70) 25.5340.3 (PIN 420 9444 71) 25.5340.5 (PIN 420 9444 72)