1989 Ski-Doo Repair Manual, Page 286Get this manual
Section 03 TRANSMISSION Sub-section 04 (DRIVEN PULLEY)
DISASSEMBLY
Chaincasedriven pulley
All except Safari Citationand tundra, Tundra LTRemovD bearing coneKnock driven pull(lY shaft with plastic hammer and pull driven pulley out
26,27, Snap ringsupport
Remove snap ring and support using suitable puller
A002 003 029
Slider shoo
ASSEMBLY
20, Sliding half bushing
Clean mounting surfaces with Loctite Safety Solvant than apply Loctite 609Using press and suitable pusher, install bushing as illustratedWait six hours for complete cure
22,24, Roll pinouter cam
Remove roll pin and slide outer cam out of pulley shaft
INSPECTION
20,39, Sliding half bushingbushing