1989 Ski-Doo Repair Manual, Page 222Get this manual
Section 02 ENGINE Sub-section 10 (CARBURETORFUEL PUMP)
To adjust height "H" :
- Bend the contact tab of float arm until the specified height is reached
INSTALLATION
,CAUTION: Never allow throttle slide(s) to snap shutTo install carburetor on engine, inverse removal procedureContact tab
However, pay attention to the following: Inspect throttle cable and housing prior to installation- Apply thin layer of silicone sealant between carburetor rubber flange and intake cover on engineApply Loctite 242 on bolts retaining flange to intake cover if it was removed(TYPICAL)
Rubbur flange
AOOO 002 003
The illustration below shows which part of the carburetor begins to function at different throttle slide openingsSEEN FROM AIR INTAKE SILENCER
Throttle slide openings Silicone Wide open
ACOD 002 005