1989 Ski-Doo Repair Manual, Page 190Get this manual
Section 02 ENGINE Sub-section 07 (583 ENGINE TYPE)
Tighten puller bolt and at same time, tap on bolt head using hammer to release magneto irom its taper
- Install new receptacle connector to the black iyellow striped wire- To install the ground connector to the armature plate, tape the new black lead to the old one and pull it under the lighting coil with the old wireSolder an eye connector to the lead and fasten it under the wire retaining clip
2Generating coil
To replace generating coil:Heat the armature plate to 93C (200F) around the screw holes to breal{ the Loctite bond
1.001 OCQ
4,7Generating coil screwLoctite 242
To install the new coil on the armature plate, remove the shipping nuts from the new coil and applv LDctite 242 Iblue, medium strength) to screws before assemblyUse magneto coil centering tool (PIN 420 8769 22) before tightening screwsMagn9to (:oil cS(lterlng tool