1989 Ski-Doo Repair Manual, Page 135Get this manual
Section 02
(503 ENGINE TYPE)
SUb-section 06
2, Generating coil
To replace generating coil- Heat the armature plate 10 93C (200F) around the screw holes to break the Loctite bond
- To install the ground connector of the armature pia Ie, tape the new black lead to the old one and pull it under the lighting COil with the old wire- Solder an eye connector to the lead and fasten it under the wire retaining Clip'"fe retaining clip
Heat Protect harness from flame
.0.001 002003