1989 Ski-Doo Repair Manual, Page 103Get this manual
Section 02 ENGINE Sub-section 04 (467 ENGINE TYPE)
2, Generating coil
To replace generating Coil:Heat the rmature plate to 93 (200 Fl around the screw holes to break the l.octite bond
- To install the ground connector to the armature platetape the n&IV black lead to the old one and pull it under the lighting coil with the old wire- Solder an eye connector to the lead and fasten it under the wire retaining clip
Protect
from flame
4,7, Generating coil screwLoctite 242
CAUTION: Protect harness from flame- To install the new coil on the armature plate, remove the shipping nuts from the ne-.v coil and apply I{)ctite 242 {blue, medium strength) to screws before assemblyUse magneto coil centering tool {PEN 420876922) before tightening screwsMaglltllu vuil