1989 Ski-Doo Repair Manual, Page 102Get this manual
Section 02 ENGINE Sub-section 04 (467 ENGINE TYPE)
NOTE: The following procedures can be done without removing the engine from chassis
CLEANING
Clean all metal components in non-ferrous metal cleaner
NOTE: It should be noted that to correctly remove Loctite locked fastener it is first necessary to tap on the fastener to break" Loctite" bond This will eliminate the possibility of thread breakage
11, Flywheel
To remove magneto housing (flywheel)- Lock crankshaft with crankshaft locking tool as illustrated Adjust magneto housing puller (P IN 420 8760 65) and puller ring (PIN 4208766 55) as illustrated
CAUTION: Clean armature and magneto using only clean cloth
DISASSEMBLY
To gain access to magneto assembly, remove:muffler rewind starterstarting pulley
NOTE: Before disassembling magneto plate, indexing marks should be scribed to facilitate reassembly