1989 Ski-Doo Repair Manual, Page 100Get this manual
Section 02 ENGINE Sub-section 04 (467 ENGINE TYPE)
Position the crankcase halves together and tighten bolts
by hand, then install and tighten armature plate on magne-
1,29, Loctite 242crankcase stud
At assembly on crankcaseapply Loctite 242 threads
to side to correctly align crankcase halvesTorque bolts a$ specified following illustrated sequenceFollow sequence shown
24, Crankcaseengine bracket nut
Torque the crankcaseengine bracket nut to 38 N-m (28 Ibf-ftl
1 to 1422 N.m (16 Ibf.ltl 15 and 1610 N.m 190 Ib-)
1,2, Loctite 242upper crankcase stud
Because of cap nuts, cylinder studs have to be screwed into the crankcase so that they do not exceed further than 56.5 mm (2.22 inl