1989 Ski-Doo Repair Manual, Page 83Get this manual
Section 02 Sub-section 03
(377 ENGINE TYPE)
Use magneto coil centering tool (PIN 420 8769 22) before tightening screws
- Solder the yellow black striped wire in the harness to the black tube protected wire of the coil
Slack protector with yellowiblaclr wire of harness
10001 002006
WlJite protector with yellow wire of harness
- Position protector tubes (Her connectionsMagnelo coil cantering tool IP4:0 8769 22)
101_003
- Prior to assemblyapply loctite 242 {bluemedium strength) on the lighting coil screwsUse magneto coil centering tool (P 420 8769 221 before tightening screws