1989 Ski-Doo Repair Manual, Page 63Get this manual
Section 02 ENGINE Sub-section 02 (253 ENGINE TYPE)
23, Magneto flywheel
To remove:Unscrew magneto retainillg nut and install the suitable puller as shown 4'!Y
PIN 420876065 Protect harness from flame
Aom 002003
PIN 420876655 ' Magneto housing puller and ring
A003 002 006
CAUTION: Protect harness from flame
- Remove screvits (use Phillips no2 or suitable flat screw driver)- Cut the four wires as close as possible to the coil body- To new cOil wires in harness, tape the old wires to the end of new wires and pull them through the harness protector tube- Insert the new wires and install connectorsthe old connector housing
NOTE: For the above procedure, the locking type puller can be used without crankshaft locking tool