1986 Ski-Doo Factory Shop Manual, Page 489Get this manual
Section 07 CHASSiS Sub-section 01 (HOOD)
Repair of plastic materials:
Fiberglass:
This material IS repairable and repaintable, using anyone of the many kits available on the market R.I.Murethane:
- Check surface for smoothness:Using chlorinated solvent, remove any dirt, or grease from the inside area,Sand or scuff the underside of damage area with 80 grit sand paper, exceeding it by at least 50 mm (2") all around
CHARACTERISTICS:
- Resist Impacts to apprmdmately -40"c,Repairable and repaintable with flexible type paint that uses an acrylic or polyurethane base,
- Apply 3M autobody repair tape
Inside surface
, CAUTION: Battery acid may slowly attack the plastic materialIf some acid is spilled on the materialclean immediately with solution of sodium bicarbonate and water then rinse with clean tap
, CAUTION: If welding is to be done near the R.I.M
material, it is recommended to either remove the plastic part from the area or to protect it with nium foil to prevent damageTo repair, follow the procedure below: