1986 Ski-Doo Factory Shop Manual, Page 485Get this manual
Section 06 STEERINGJSKIS Sub-section 02 (SKI SYSTEM)
7,11,37,38, Screw, screw stoppernut
(control arms)
Torque nut 11 to 85 N-m (63 Ibf-ftj Torque screw 7, 37 to 29 N.m (21 Ibf.ftl Bend tab of stopper screw 38 over flat of screw headFor steering arm Installation and tightening torque, refer
NOTE: Before attempting to compress the shock spring, push the rubber bumper on the piston shaft against the shock body
to "Steering" section 06-01
59, Stop bounding
Install wilh the molded indication "front" forward
"0'5005026
60,66,67,77, Ski, slotted nut, cotter pinwasher
Torque nut to 40 N-m (30 IbfWMake sure ski moves easilyInstall washer and cotter pm,
Install the shock spring remover over the spring_ Insert vis pin through the shock eye and secure it with the hair pin_ Tjghten the bolt until the spring stopper can be removed
LUBRICATION
Refer to "Steering" section D6-Dt