1986 Ski-Doo Factory Shop Manual, Page 475Get this manual
Section 06 STEERINGSKIS Sub-section 01 (STEERING SYSTEM)
- Place angle finder outside of ski leg housing
- Close front of skis manually to take all slack from steering mechanism, Skis should have toe-out of mm (18") when they are in straight-ahead position
WARNING: Never lengthen tie rod SO that threaded portion of ball joints exceeds 17 mm (11!16") out side tie rodTo avoid this, vary length of other tie rod- Torque jam nuts 3234 to 29 N-m (21 Ibf-ftl
LUBRICATION
WARNING: Do not lubricate throttle andor brake cable and housings, and spring coupler bolts
46,92, Ski leggrease fittings
Using low temperature grease only (PIN 413 7056 00)Lubricate the ski legs at grease fittings until new grease appears at JOints, lubricate tie rod end ball joints(TYPICALI
- loosen both upper control arm jam nuts and adjust its length TO obram vertical ski leg (0 05" Torque jam nuts to 29 N-m (21 Ibf-Wlower vehicle to ground
Formula MXPI.us