1986 Ski-Doo Factory Shop Manual, Page 472Get this manual
Section 06 STEERINGSKIS Sub-section 01 (STEERING SYSTEM)
Another way to install grips consists soaking them in soapy water (detergent for dishes) and in pushing them onto the handlebar with soft hammer
U-L SHQWN
SWing arf!1
cenler line
29,35 Ball joints
Inspect ball Joint ends for wear or looseness, if excessive, replace
NOTE: Screw the longest threaded end of ball loint into the tie rod, ensure that half of the total number
AO,500600
of threads are inserted into the tie rod
The cut-off section of the tie rod end must run parallel with the horizontal line of the steering arm when assembled on vehicleThe tie rod end should be restrained when tightening tie rod end lock nutFor torque specifications see illustrationsOpen wrench
Sleerin(l arm
25,30,100,105, Bait joint nuts, lock tabsscrew stopper
Tighten ball jOint nuts to specified torque (see illustration) and bend lock tabs over nuts
Tie rod end
25,30,31, Steering arm nutslock tabs
Tighten steering arm nuts to specified torque (see tration) arld bend lock tabs over nuts