1986 Ski-Doo Factory Shop Manual, Page 463Get this manual
Section 05 SUSPENSION Sub-section 08 (TRACK) Turn track adjuster bolt on same side, clockwise until track re-alignsTighten link plate spring lock nut_
To adjust loosen the rear Idler wheel retaining screw mot required on Citation LS, LSE, models) and the adjuster bolt lock nut; then loosen or tighten the adjuster bolts located on the inner side of the rear idler wheels
Alignment (slide suspension all models)
With rear of vehicle supported off the ground, start engine and allow the track to rotate slowlyCheck that track is welJ centered and turns evenlyTo correct, stop engine then loosen the lock nuts and tighten the adjuster bolt on side where guides are farthest to slideTighten lock nuts and recheck alignment
(TYPICAL)
Rel3lning screw
AQ0100S003
NOTE: On the Formula MXPlus, torque retaining
screw to 48 N.m (35 Ibf.W after adjustment
(TYPICAL)
NOTE: ]f the track tension is too loose, the track will have tendency to thump,